Angular Filters C series

APPLICATIONS: Where and when extra protection is required. It can also help for the prevention of slag in suction lines and the pumps.
USAGE: C-series screen filters are used for filtration of water with low concentration of inorganic suspended solids (e.g., sand). Also, it can be used as a secondary filter after primary filtration systems (e.g., media filter, hydro-cyclones etc.). They are also available with double cartridge for 2-stage filtration.
INSTALLATION: The installation of the filter is done by following the direction of the flow arrow in the filter body. Water enters the inlet, passes through the cartridge, is filtered, and exits from the outlet. The angle between inlet-outlet is 90⁰.
MAINTENANCE: The filter is cleaned manually, disassembling the lid and removing the cartridge. The cleaning of the cartridge should always be done when the difference of input-output pressure is 0.5 bar greater than the pressure difference while the cartridge is clean.


BODY: Steel S235JR (also available in stainless steel AISI 304 & 316, upon request)
CARTRIDGE: u-PVC (DIN8061-8062)/ stainless steel screen (AISI 304)/ perforated stainless steel (for models greater than 6’’)
SURFACE TREATMENT: Chemical cleaning (pickling, phosphate) and electrostatic painting with polyester powder (available epoxy coatings suitable for drinking water)
AVAILABLE SCREEN SIZES: 60 mesh/ 250μm, 80 mesh/ 180 μm, 120 mesh/ 125μm, 140 mesh/ 106 μm, 170 mesh/ 90 μm, other sizes upon request

TF: Threaded Female BSP | F: Flanged, DIN 2567 PN10 | G: Grooved upon request

Angular Filters C series table001
Angular Filters C series table002
headloss c series drop

Part list

Part list 05-02-200
Part list 05-02-201
Part list 05-02-202
Part list 05-02-203
Part list 05-02-250
Part list 05-02-300
Part list 05-02-301
Part list 05-02-303
Part list 05-02-400
Part list 05-02-401
Part list 05-02-403
Part list 05-02-600